Re: BGP from Juniper to Cisco ASR

[Eric A Louie <elouie () yahoo com>]

When I had that problem, it was because the max-prefixes on the Juniper router was being triggered.   If I remember 
correctly.  It's a strange return message for the wrong issue.





> ________________________________
> From: Philip Lavine <source_route () yahoo com>
> To: NANOG list <nanog () nanog org> 
> Sent: Wednesday, December 18, 2013 7:48 AM
> Subject: BGP from Juniper to Cisco ASR
>
>
> Dec 18 07:46:33: %BGP-3-NOTIFICATION: received from neighbor <REMOTE PEER> active 2/5 (authentication failure) 0 bytes 
> Dec 18 15:46:33.615: BGP: ses global <REMOTE PEER> (0x7FB1CD209CF0:0) act Receive NOTIFICATION 2/5 (authentication 
> failure) 0 bytes 
>
> Although I have seem this on the message boards I am little confused in that the ISP is telling me that there is no 
> authentication enabled on the Juniper and I do not have authentication enabled on the ASR. So what is going on here?