Re: Wireshark parameter

[NITIN GOYAL <nitinkumgoyal () gmail com>]

If you are doing RTSP/RTP stream, data will be RTP over UDP.

Check where your actual data is coming over which protocol. Then you can
make the filter. There are ways where you can calculate the jitter values
etc for that data. Also, I have said for jitter etc there is already an
analyser in Wireshark which do all that.

On Thu, Nov 20, 2014 at 6:56 PM, Oriplatform Dp <oriplatform85 () yahoo com>
wrote:

> Thanks for your reply,
>
> Actually, I want these parameters and I ask to this mailing list because
> I'm not get them.
> I have about 4 files (.pcapng) each scenario.
>
> I'm confused about TCP, UDP, or both are unrelated.
>
> In the scenario 1, the list of protocols in the wireshark are
> ARP
> ICMP
> OLSR V1
> TCP (the most)
> UDP
>
> in the scenario 2, they are
> ARP
> ICMP
> OLSR V1
> RTP (the most)
> UDP
>
> regards
>
>
>
>
>
>   On Tuesday, November 18, 2014 4:43 PM, NITIN GOYAL <
> nitinkumgoyal () gmail com> wrote:
>
>
>
> On Mon, Nov 17, 2014 at 10:17 PM, Oriplatform Dp <oriplatform85 () yahoo com>
> wrote:
>
>
> I'm looking for the value of this parameter in wireshark:
> end-to-end delay, throughput, packet loss, and jitter.
>
> I've done a couple of scenarios.
> 1. I send a file from one node (192.168.100.1) to another node
> (192.168.100.6) using file transfer software in the LAN.
> 2. I'm broadcasting (192.168.100.1) video via VLC using RTSP protocol and
> the one of the other node (192.168.100.6) streams that video.
>
>
>
> Your question is not clear. You want these parameters or you are not
> getting them? If the media or dat is sent over RTP with RTSP, there is one
> RTP analyser which will give all of these params.
___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
             mailto:wireshark-users-request () wireshark org?subject=unsubscribe