Re: non-ASCII stuff in manuf

[Thomas Boehne <TBoehne () ADwin de>]

On 10/26/2010 11:32 AM, Thomas Boehne wrote:
> I contacted them a couple of times concerning this, but the requests
> would either not be answered at all or were forwarded to people that
> could not fix the problem. I will try it again today, or probably call
> them until I finally reach somebody that can help.

After sending a bunch of emails to IEEE explaining the problem in
detail, they finally changed the database entries today.

The bad news is that they are now _both_ displayed incorrectly on the
web page (if the browser decides to display the page as unicode).

The good new is that they are both displayed _correctly_ in wireshark,
since make-manuf decodes the database as iso-8859-1.

Could someone please run make-manuf to update manuf and check it in?

Best regards
Thomas Böhne

-- 
**************************************************************************
* Jäger Computergesteuerte Messtechnik GmbH
* Thomas Böhne
* Rheinstraße 2-4
* 64653 Lorsch, Germany
* http://www.ADwin.de
* Phone: +49 (6251) 9632-0                  Fax: +49 (6251) 56819
**************************************************************************
* Responsible: C.E.O. Hubert Morgenstern
* Commercial Register: Amtsgericht Bensheim, Register no.: B24717
**************************************************************************
___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
             mailto:wireshark-dev-request () wireshark org?subject=unsubscribe