RE: [EXTERNAL] Juniper configuration recommendations/BCP

["Mann, Jason via NANOG" <nanog () nanog org>]

If using loopbacks on the router you have to have a firewall filter on it to permit traffic to the device even if you 
have a firewall filter on individual interfaces that would allow/deny traffic

From: NANOG <nanog-bounces+jamann=mt.gov () nanog org> On Behalf Of Forrest Christian (List Account)
Sent: Thursday, October 8, 2020 3:38 AM
To: nanog list <nanog () nanog org>
Subject: [EXTERNAL] Juniper configuration recommendations/BCP

<ISP hat on>
After nearly 30 years of being a cisco shop, I'm working on configuring our first pair of Juniper MX204's to replace 
our current provider-edge cisco.

I've worked through enough of the Juniper documentation/books to have a fairly good handle on how to configure these, 
but I wanted to check with the list to see if there are any Juniper-Specific gotchas I might run into that isn't 
documented well.

I've done a bit of googling and am either finding stuff that is largely Cisco-specific or which is generic - all of 
which I'm rather familiar with based on my past history.   Is there anything I should worry about which is 
Juniper-specific?

--
- Forrest