nanog mailing list archives
Re: OT: Below grade fiber interconnect points
From: Shawn L <shawnl () up net>
Date: Thu, 14 Nov 2013 09:01:07 -0500
There are a couple of ways to do this. If you're going to keep everything below grade in a man hole or cable vault of some type, you definitely need to have it in a sealed splicing enclosure. That means instead of using a patch panel, everything has to be fusion spliced. You'll get less loss because it's a direct splice, but changing things later becomes a pain. The other option is to use an outdoor fiber patch cabinet / pedestal. There are multiple outdoor rated above ground fiber cross connect cabinets available that you could probably find an unobtrusive place to install. Or, there are several manufacturers (3M, etc.) that make fiber cross connects that fit in a plastic version of a standard telco pedestal which you could pretty much place anywhere. On Wed, Nov 13, 2013 at 9:04 PM, Justin M. Streiner <streiner () cluebyfour org
wrote:
On Wed, 13 Nov 2013, Roy Hockett wrote: Thank you for comments. Let me clarify the situation. We have a buildingthat has been fiber cross connect location and is being demolished. This location has about 20 fiber cable entering where we patch between fiber paths. If we relocated these cross connect field to another building and that build is demolished we have to do this all over again, so the desire was to have an independent facility for the fiber cross connect field, but I am guessing due to esthetics the below ground vault was selected, we just learned of this selection and thus my query to this group to find other that have dealt with similar situations and if so, experience base recommendations, and things to be aware of.If the vault has a controlled environment and access, similar to what you would find inside of a comms room, that's one thing. If it's more like a typical manhole (damp, dirty, dark, possible temperature extremes, other utilities/hazards), then the only thing that should be in there is a water-tight splice case. Fiber patches need to be in a clean environment. Did this project provide any funds for relocation or replacement of the communications facilities that would be lost due to the demolition? We've gone through this many times on our campus. jms
Current thread:
- OT: Below grade fiber interconnect points Roy hockett (Nov 13)
- Re: OT: Below grade fiber interconnect points Justin M. Streiner (Nov 13)
- Re: OT: Below grade fiber interconnect points Thomas (Nov 13)
- Re: OT: Below grade fiber interconnect points Jeff Kell (Nov 13)
- Re: OT: Below grade fiber interconnect points Roy Hockett (Nov 13)
- Re: OT: Below grade fiber interconnect points Justin M. Streiner (Nov 13)
- Re: OT: Below grade fiber interconnect points Thomas (Nov 14)
- RE: OT: Below grade fiber interconnect points Sam Roche (Nov 14)
- RE: OT: Below grade fiber interconnect points Joe McLeod (Nov 14)
- Re: OT: Below grade fiber interconnect points Shawn L (Nov 14)
- Re: OT: Below grade fiber interconnect points Thomas (Nov 13)
- Re: OT: Below grade fiber interconnect points William Allen Simpson (Nov 14)
- Re: OT: Below grade fiber interconnect points Justin M. Streiner (Nov 13)
- Re: OT: Below grade fiber interconnect points Jay Ashworth (Nov 15)
- Re: OT: Below grade fiber interconnect points Michael Sinatra (Nov 15)
- Re: OT: Below grade fiber interconnect points Jay Ashworth (Nov 15)
- Re: OT: Below grade fiber interconnect points Gary Buhrmaster (Nov 15)
- Re: OT: Below grade fiber interconnect points Michael Sinatra (Nov 15)
- Re: OT: Below grade fiber interconnect points Jay Ashworth (Nov 15)