Wireshark mailing list archives
Re: Requesting command to decode UDP packet to RTP
From: Hugo van der Kooij <hugo.van.der.kooij () qsight nl>
Date: Fri, 7 Apr 2017 06:53:37 +0000
This message contains a digitally signed email which can be read by opening the attachment. Hugo van der Kooij network engineer QSight IT T : +31 15 888 0 345 F : +31 15 888 0 445 E : hugo.van.der.kooij () qsight nl I : http://www.qsight.nl Arnhem - Delft - Veldhoven
--- Begin Message --- From: Hugo van der Kooij <hugo.van.der.kooij () qsight nl>
Date: Fri, 7 Apr 2017 06:53:37 +0000
This is why Laura always pushes you to use profiles. And frankly. I couldn't use wireshark without them. Met vriendelijke groet / With kind regards, Hugo -----Oorspronkelijk bericht----- Van: wireshark-users-bounces () wireshark org [mailto:wireshark-users-bounces () wireshark org] Namens Guy Harris Verzonden: Thursday, 6 April, 2017 22:23 Aan: Community support list for Wireshark <wireshark-users () wireshark org> Onderwerp: Re: [Wireshark-users] Requesting command to decode UDP packet to RTP On Apr 6, 2017, at 1:04 PM, Jaap Keuter <jaap.keuter () xs4all nl> wrote:... but isn't it always the same story; "how to get UDP dissected as RTP"? I can't remember the question being asked the other way around....Enabling the heuristic solves two problems: "how to get UDP traffic that's RTP traffic dissected as RTP" and "how to get UDP traffic that's *not* RTP traffic *mis*dissected as RTP". :-) It's a *very* weak heuristic, and could get a lot of non-RTP traffic misdissected as RTP. Therefore, you might not want to permanently turn the heuristic dissector on - you might want to turn it on for some captures but leave it off for others. ___________________________________________________________________________ Sent via: Wireshark-users mailing list <wireshark-users () wireshark org> Archives: https://www.wireshark.org/lists/wireshark-users Unsubscribe: https://www.wireshark.org/mailman/options/wireshark-users mailto:wireshark-users-request () wireshark org?subject=unsubscribeAttachment: smime.p7s
Description:
--- End Message ---
___________________________________________________________________________ Sent via: Wireshark-users mailing list <wireshark-users () wireshark org> Archives: https://www.wireshark.org/lists/wireshark-users Unsubscribe: https://www.wireshark.org/mailman/options/wireshark-users mailto:wireshark-users-request () wireshark org?subject=unsubscribe
Current thread:
- Requesting command to decode UDP packet to RTP mahadevaswamy.h.n Swamy (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Jaap Keuter (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Guy Harris (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Jaap Keuter (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Guy Harris (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Jaap Keuter (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Hugo van der Kooij (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Guy Harris (Apr 06)
- Re: Requesting command to decode UDP packet to RTP Jaap Keuter (Apr 06)