Wireshark 2 RPC Reassembly Bug?

[Paul Offord <Paul.Offord () advance7 com>]

Hi,

I get the following when reading RPC v2 packets from a pcap file with a snaplen of 96 bytes:

C:\Development\Wireshark\epan\reassemble.c:1223: failed assertion "tvb_bytes_exist(tvb, offset, frag_data_len)"

I noticed a similar bug report for 1.12.5 - see Bug 11198<https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=11198>

I'm not sure of the correct way to report this.  Do I just add a note to the above bug or should a I create a new one 
specifically for Wireshark v2.

Thanks and regards...Paul



______________________________________________________________________

This message contains confidential information and is intended only for the individual named. If you are not the named 
addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if 
you have received this e-mail by mistake and delete this e-mail from your system.

Any views or opinions expressed are solely those of the author and do not necessarily represent those of Advance Seven 
Ltd. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, 
corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept 
liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission.

Advance Seven Ltd. Registered in England & Wales numbered 2373877 at Endeavour House, Coopers End Lane, Stansted, Essex 
CM24 1SJ

______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please visit http://www.symanteccloud.com
______________________________________________________________________

___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev () wireshark org>
Archives:    https://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
             mailto:wireshark-dev-request () wireshark org?subject=unsubscribe