Re: iperf UDP throughput

["netztier () bluewin ch" <netztier () bluewin ch>]

Well, it says so:

D:\iPerf>iperf --help

[...]

Client specific:
  -b, --bandwidth #[KM]    for UDP, bandwidth to send 
at in bits/sec
                           (default 1 Mbit/sec, implies -u)
[...]

regards

Marc

-- 
netztier@bluewin.
ch


> ----Ursprüngliche Nachricht----
> Von: abhishekfishy2000 () gmail com
> Datum: 27.03.2012 10:40
> An: "Community 
support list for Wireshark"<wireshark-users () wireshark org>
> Betreff: [Wireshark-users] iperf UDP throughput
>
> Hello 
All,
> This is not exactly a wireshark question still posting here and this list
> gives very good explanations.

> I'm using Wifi in g mode and WPA2AES between an Linux AP and Windows STA
>
> I initiated a iperf TCP client|server for 
90 sec and observed throughput
> was 11Mbits/sec
> With UDP its just 1.04Mbits/sec
>
> Wireshark shows both TCP and UDP 
packets transmitted at 54 or 36 Mb/s.
> I'm not able to understand why is UDP throughput so low
>
> commands
>
> iperf -
s -u   (Win 7 STA)
> iperf -c <IP> -u -t 90  ( linux AP)
>
> regards
> Abhishek

___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
             mailto:wireshark-users-request () wireshark org?subject=unsubscribe