Wireshark mailing list archives
Re: decoding IuPS traffic
From: "Anders Broman" <anders.broman () ericsson com>
Date: Fri, 30 Oct 2009 15:54:31 +0100
Hi, Edit->preferenses->DLT_USER->Edit Pops up the Users DlT table Press New (or edit if DLT 147 exists) Enter sscop in payload protocol Header size 0 Trailer size 0 Ok, OK/Apply Regards Anders -----Original Message----- From: wireshark-users-bounces () wireshark org [mailto:wireshark-users-bounces () wireshark org] On Behalf Of Roger Mahler Sent: den 30 oktober 2009 14:32 To: wireshark-users () wireshark org Subject: [Wireshark-users] decoding IuPS traffic Hello all in older versions of Wireshark (e.g. 0.99.2) there was under "Preferences"-->"Protocols" --> DLT User A,B,C,D. I was able to make use of one such DLT by setting "Special Encapsulation" to "SSCOP" and "Payload" to "sscf-nni". With these settings I was able to decode IuPS traffic with SSCOP:SSCF-NNI:MTP3b:SCCP:RANAP Since a while back the DLT User A,B,C,D has disappeared. Instead the GUI offers a table. How do I have to fill this table to achieve the same result as before? (or any other ideas how to make the newer versions of Wireshark decode the attached frame?) Cheers Roger ___________________________________________________________________________ Sent via: Wireshark-users mailing list <wireshark-users () wireshark org> Archives: http://www.wireshark.org/lists/wireshark-users Unsubscribe: https://wireshark.org/mailman/options/wireshark-users mailto:wireshark-users-request () wireshark org?subject=unsubscribe
Current thread:
- decoding IuPS traffic Roger Mahler (Oct 30)
- Re: decoding IuPS traffic Anders Broman (Oct 30)