dnet: Failed to open device eth0 QUITTING!

[Ruggero DallAglio <ruggero.dallaglio () yahoo it>]

Broke my embedded NIC, I used a recycled pci NIC.
While trying to use nmap (ver. 6.47, both command line or Zenmap same version) with Winpcap ver. 4.1.3, the following 
output is displayed:

Starting Nmap 6.47 ( http://nmap.org ) at 2015-05-21 09:56 ora legale Europa occidentale

NSE: Loaded 118 scripts for scanning.

NSE: Script Pre-scanning.

Initiating ARP Ping Scan at 09:56

dnet: Failed to open device eth0

QUITTING!

here's the ouput of nmap --iflist

Starting Nmap 6.47 ( http://nmap.org ) at 2015-05-21 10:13 ora legale Europa occ
identale
************************INTERFACES************************
DEV  (SHORT) IP/MASK         TYPE        UP   MTU  MAC
eth0 (eth0)  x.x.x.2/n       ethernet    up   1500 omissis
eth1 (eth1)  x.x.x.39/n      ethernet    down 1500 omissis
lo0  (lo0)   ::1/128         loopback    up   -1
lo0  (lo0)   127.0.0.1/8     loopback    up   -1
tun0 (tun0)  (none)/0        point2point down 1280

DEV  WINDEVICE
eth0 <none>
eth1 \Device\NPF_{...snip...}
lo0  <none>
lo0  <none>
tun0 <none>

I suppose the first NIC when I installed nmap was eth0 with ip address ending with 39. Again, I think the new device 
got the new ip address (ending 2).
Above, eth0 (old nic?) has the new ip address, but it's not listed under WINDEVICE column, while eth1 (new?) has the 
old ip and is listed under WINDEVICE column.
No Preferences nor Settings in Zenmap menus to select NIC to use or update configuration.

Thanks and....great tool Fyodor!!!
 

_______________________________________________
Sent through the dev mailing list
https://nmap.org/mailman/listinfo/dev
Archived at http://seclists.org/nmap-dev/