Nmap Development mailing list archives
Getting Elapsed time and the Nmap does Not generate the Report
From: Abu Faisal Tauheed <Abu.Tauheed () aricent com>
Date: Sun, 24 Feb 2013 21:50:36 +0530
Hi Team I am using the latest Nmap 6.25 for the port scanning. I have configure ACL on the Node(Network Element) which will block all the tcp and udp traffic except some. Observed behavior : When I have the above configuration in the NODE and start the UDP scan alone on Nmap, it does not generate any report and it takes forever to complete the execution (actually it never complete the execution). Expected behavior : It should generate the report stating the all the UDP ports are closed on the respective IP address. But when I allow the desire UDP traffic on the NODE ,then start the Nmap UDP scan then it generate the report. As per my understanding it should generate the report in either case. When I was using Nmap 6.01 then I did not face this problem, It only started happening from Nmap 6.25. I am unable to find the 6.01 from your website, If possible can you please provide me the Nmap 6.01 so I can test and re-confirm you guys. Regards Abu =============================================================================== Please refer to http://www.aricent.com/legal/email_disclaimer.html for important disclosures regarding this electronic communication. =============================================================================== _______________________________________________ Sent through the dev mailing list http://nmap.org/mailman/listinfo/dev Archived at http://seclists.org/nmap-dev/
Current thread:
- Getting Elapsed time and the Nmap does Not generate the Report Abu Faisal Tauheed (Feb 25)
- Re: Getting Elapsed time and the Nmap does Not generate the Report David Fifield (Feb 27)