Nmap Development mailing list archives
Re: Nmap 4.60 errors - Failed to open device
From: David Fifield <david () bamsoftware com>
Date: Thu, 12 Jun 2008 09:02:50 -0600
On Fri, Apr 25, 2008 at 02:09:02PM -0700, william caput wrote:
I'm getting errors when running Nmap in Vista with multiple virtual adapters. It worked fine until I installed VMWare and Andlinux. Now, I get this error when attempting a scan: Starting Nmap 4.60 dnet: Failed to open device eth4 QUITTING! I then specified my eth0 adapter. nmap -e eth0 x.x.x.x Starting Nmap 4.60 Time NmapArpCache() can only take IPv4 addresses. Sorry QUITTING! I then disabled all my interfaces except the ethernet and ran nmap: Starting Nmap 4.60 Time dnet: Failed to open device eth3 QUITTING! Any suggestions? Thanks.
Hi William. Please send the output of running nmap --iflist WinDump -D You can get the WinDump program from http://www.winpcap.org/windump/install/. Make sure you are running Nmap in an elevated command prompt. Also please try it with the official WinPcap 4.0.2 installer, available at http://www.winpcap.org/install/default.htm. Remove the Nmap winpcap from "Add or Remove Programs" first, then run the installer. David Fifield _______________________________________________ Sent through the nmap-dev mailing list http://cgi.insecure.org/mailman/listinfo/nmap-dev Archived at http://SecLists.Org
Current thread:
- Nmap 4.60 errors - Failed to open device william caput (Apr 25)
- Re: Nmap 4.60 errors - Failed to open device David Fifield (Jun 12)