Re: Extending network over a dry pair

[Shawn L via NANOG <nanog () nanog org>]

Actellis also makes some ethernet over dry pair gear.  The only issue is that they require repeaters like a T1 
(different spacing though).  I'm guessing if you're doing T1 at that distance you already have repeater housings in the 
field at least.
 
 


-----Original Message-----
From: "Alfie Pates" <alfie@fdx.services>
Sent: Wednesday, December 12, 2018 4:42pm
To: nanog () nanog org
Subject: Re: Extending network over a dry pair



Six miles is probably pushing it, but Proscend make some interesting Long-Range Ethernet SFP transciever which are VDSL 
based. They're horrendously documented and they draw *way* more power than the SFP specification allows.
They also make a version which is design to terminate VDSL broadband circuits - A couple of those found their way to my 
desk recently and it turns out that despite the horrendous documentation and sightly scary heat output (they come with 
a little paper note in the box which says something along the lines of "WARNING! MODULE GETS HOT - DO NOT TOUCH DURING 
OPERATION."), they do generally Just Work!
~a
On Wed, Dec 12, 2018, at 9:25 PM, Nick Bogle wrote:
A quick question for you guys; 
If you had a single dry pair (pair of copper wires originally for phones) to a remote site that was around 6 miles 
away, what would you use? We currently are just extending a T1 line to this site, but 1.5Mbps isn't cutting it anymore. 
Unfortunately it's a research site on a federally protected wildlife preserve so we can't run any new infrastructure 
(fiber etc) and it isn't in a geographical place where point to point wireless is practical. We were thinking there is 
some sort of network extender that uses some form of DSL for higher bandwidth capacity. 
Any suggestions?