nanog mailing list archives

Re: Question about migrating to IPv6 with multiple upstreams.


From: Owen DeLong <owen () delong com>
Date: Tue, 14 Jun 2011 10:50:15 -0700


On Jun 14, 2011, at 10:28 AM, William Herrin wrote:

On Tue, Jun 14, 2011 at 1:04 PM, Ray Soucy <rps () maine edu> wrote:
I think in the long term telling everyone to jump into the BGP table
is not sustainable; and not operationally consistent with the majority
of SMB networks.

A better solution; and the one I think that will be adopted in the
long term as soon as vendors come into the fold, is to swap out
RFC1918 with ULA addressing, and swap out PAT with NPT; then use
policy routing to handle load balancing and failover the way most
"dual WAN" multifunction firewalls do today.

Example:

Each provider provides a 48-bit prefix;

Internally you use a ULA prefix; and setup prefix translation so that
the prefix gets swapped appropriately for each uplink interface.  This
provides the benefits of "NAT" used today; without the drawback of
having to do funky port rewriting and restricting incoming traffic to
mapped assignments or UPnP.

Hi Ray,

There's a nuance here you've missed.

There are two main reasons for ULA inside the network:

1. Address stability (simplifies network management)
2. Source obfuscation (improves the depth of the security plan)

Option 1: Obfuscation desired.

ULA inside. NAT/PAT at both borders. You don't use prefix translation
here because prefix translation does little obfuscation: it has a 1:1
relationship with each individual host and still reveals the internal
routing structure.

Option 2: Stability, no obfuscation desired.

ULA inside, prefix translation at both borders.

Option 3: Neither stability nor obfuscation required.

GUA from one of the providers inside. Prefix translation to the other
provider for the connections desired out that border. Giving the hosts
real GUA addresses maximizes application compatibility.


If you're going to go with option 3, why not just put both GUA on the
hosts and set up proper rules for source address selection to control
the outbound preferences?

Owen



Current thread: