nanog mailing list archives
Re: Slightly OT: Redundant CPE Switching for DS3
From: Jay Hennigan <jay () west net>
Date: Thu, 22 Dec 2005 11:59:54 -0800
will () loopfree net wrote:
On Thu, Dec 22, 2005 at 12:21:55PM -0700, John Neiberger wrote:I'm curious to find out if there is a device that would allow a single DS3 to terminate on two different routers, and switch from the primary to the backup router if the primary were to fail. I've seen this for T1 circuits but I can't find anything for DS3.I'd bet you could make something workable with a DPDT coaxial relay, driving it from alarm contacts or a relay output of whatever monitoring system you might already have. The tricky part would probably be appropriately defining "failure" in order to get it toautomatically switch at the right time without causing more problems than you started with.
One probably could. More often than not it seems that the mechanism used to provide protection against hardware failure becomes more fragile than the hardware you're protecting. I've had far more issues caused by PIX failover going screwy than I've seen failed PIXen as a mild example.
Can the relay and associated hardware, cables, power supply and logic be guaranteed to be substantially more reliable than the router? If not, why bother?
Sometimes all of your eggs in one basket is the most sensible choice as long as you have a stainless steel basket.
-- Jay Hennigan - CCIE #7880 - Network Administration - jay () west net NetLojix Communications, Inc. - http://www.netlojix.com/ WestNet: Connecting you to the planet. 805 884-6323
Current thread:
- Slightly OT: Redundant CPE Switching for DS3 John Neiberger (Dec 22)
- Re: Slightly OT: Redundant CPE Switching for DS3 will (Dec 22)
- Re: Slightly OT: Redundant CPE Switching for DS3 Jay Hennigan (Dec 22)
- <Possible follow-ups>
- Re: Slightly OT: Redundant CPE Switching for DS3 John Neiberger (Dec 22)
- Re: Slightly OT: Redundant CPE Switching for DS3 will (Dec 22)