Re: How to make setup backup route for windows server

["Jason Lewis" <jlewis () packetnexus com>]

> The actual ips stay the same (they are on loopback interface on the
> windows server) so what is necessary is for cisco router to know if
> firewall is up and if so route that block of ips throuh the firewall
> and  if not, then route it directly to the server through ethernet
> interface.

Are you asking how to configure failover on two NICs in a windows server
using a virtual IP?

Sorry I can't answer the windows question, but if that is what you are
looking for on Solaris.  Check this article on samag.com.

http://www.samag.com/documents/s=1441/sam0111i/

jas