nanog mailing list archives
Re: Configuring multi-home failover
From: Travis Dawson <tdawson () bluemartini com>
Date: Fri, 18 Jan 2002 12:17:11 -0800
Two very good guides for this: http://www.nanog.org/mtg-0110/ppt/smith.pdf and http://www.cisco.com/public/cons/isp/documents/Multihoming_Draft_2_0.PDF and basically all the documents in http://www.cisco.com/public/cons/isp/documents are worth the read. Enjoy. At 11:46 AM 1/18/2002, Mike Stubbers wrote:
I am wanting to configure a secondary ISP to be used as fail over only for our primary. At this point both ISP's come into the same 7500 router and I have an established BGP session with our primary provider. Can those of you doing this already tell me the optimum way to set this up? Is this best done on my end or by having my secondary discover our disappearance and begin announcing? New territory for me so BGP configuration examples are welcome. Regards, Mike Stubbers Network Analyst Supervisor, SCP Information Technology Services University of Idaho mikest () uidaho edu
-tdawson -Network Geek (Bit Pusher)-BlueMartini Software
Current thread:
- Configuring multi-home failover Mike Stubbers (Jan 18)
- Re: Configuring multi-home failover Travis Dawson (Jan 18)
- Re: Configuring multi-home failover just me (Jan 18)
- <Possible follow-ups>
- Re: Configuring multi-home failover Stephane Bortzmeyer (Jan 18)
- RE: Configuring multi-home failover Mike Stubbers (Jan 18)
- Re: Configuring multi-home failover Travis Dawson (Jan 18)