nanog mailing list archives

Re: need routed configuration help


From: Brian Whalen <bri () sonicboom org>
Date: Tue, 15 Jan 2002 20:36:35 -0800 (PST)


if youre doing a static route, no need for routed.  As root, fire uo
/stand/sysinstall, select post install config, network interfaces, the one
you want, and have at it.  Its a fill in the blanks screen.

Brian "Sonic" Whalen
Success = Preparation + Opportunity


On Tue, 15 Jan 2002, Alex Melkomukov wrote:


Hello everyone.

I'm not sure if this is the correct list, but I was informed that this list
is where all of the routing experts can be found, so I am sending this plea
for help to this list.

Basically, I need to confirm some configuration information and make sure
I've set up everything properly.  I am seeing some very strange behavior
and need to rule out local misconfiguration as the cause.  I am not a
routing expert, so I need confirmation.

We had to configure a customer's server to function in a co-location
facility (not of our choosing) that has a gateway IP address that is
outside of the locally defined network block (Class C).

The OS is FreeBSD 4.4.  I did some digging and discovered that I needed to
enable 'routed' and create some static routes to the gateway IP outside of
the local network block to be able to reach the Internet.

I uncommented the

    defaultrouter="5.6.7.1"

entry (IP has been changed to protect parties involved) in the rc.conf file
and added the

    router_enable="YES"

entry.  I then added the following entries to the rc.local file:

    route add default -interface 1.2.3.100 -netmask 255.255.255.252
    route add -net 5.6.7.1 -interface 1.2.3.100 -netmask 255.255.255.252
    route add default 5.6.7.1

I came up with these routes by trial and error, and am not convinced that
these are the correct entries to use.

I can reach the Internet and the nameserver (which is also outside of the
local network block), and can ping and traceroute without any problems.

But,...  every once in a while certain programs start timing out and/or
take a really long time to respond (to the point of failure due to time-out
on the other end).  Some of these programs are telnet, ssh, ftp, radius.

Other programs/protocols (such as http traffic) do not display the same
behavior.

So, I am seeking advice on how to configure static routes correctly and/or
if some other issues may be causing this strange, intermitten behavior.

Please let me know if I implemented this incorrectly...

am
   __________________________________________________________________
   Alex Melkomukov                               amelkomukov () navi net
   Navi.Net                                       http://www.navi.net
   618 NW Glisan St., Ste. 101                     voice 503-517-8866
   Portland, OR  97209 USA                           fax 503-517-8868
   ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~



Current thread: