RE: Identifying DoS-attacked IP addresses)

["Pena, Antonio" <antonio_pena () verestar com>]

Hello Andre

The best way we use to identify DOS attacks is measuring and monitoring the backbone circuits the packets/second in and 
out, normally most of the DOS attacks generated a lot of packets/second, in our case we created an alarm that sends an 
email and page each time any of our backbone circuits exceed 17000 Packets/second, second alarm when packets exceed 20k 
using Intermapper 3.6 and SNMP.

After this is you are using the Cisco 12000 is no problem to try of detect the type of traffic using Extended 
Access-list and sending to the loggin for 15-20 seconds and then look for ICMP, UDP and TCP, in our case we found 7 of 
ten DOS attacks target IP's and only 10% are coming from known sources, most of the attacks used smurfed sources.

Regards;

Antonio J. Pena
Senior Manager, Network Engineering
 
(  /_ _ _  __/_ _ 
|_/(-/ (-_) /(//  
Verestar, inc.
3040 Williams, Dr Suite 100
Fairfax, VA, 22031
Phone (703)206-9000
Direct (571)226-5772
Fax (703) 573-3522
antonio_pena () verestar com
http://www.verestar.com

-----Original Message-----
From: Andre Chapuis [mailto:chapuis () ip-plus net]
Sent: Monday, December 16, 2002 9:12 AM
To: nanog () nanog org
Subject: Identifying DoS-attacked IP address(es)



Hi,
How do you identify a DoS-attacked IP address(es) on your ingress border router, assuming the latter is a Cisco 12000 ? 
I used to use ip accounting but they removed it from the S-code.
Thanks,
André


---------------------
Andre Chapuis
IP+ Engineering
Swisscom Ltd
Genfergasse 14
3050 Bern
+41 31 893 89 61
chapuis () ip-plus net
CCIE #6023
----------------------