Firewall Wizards mailing list archives
Need to PAT several Networks on Symantec 7.0 firewall.
From: "Jacob, Raymond A Jr" <raymond.jacob () navy mil>
Date: Fri, 26 May 2006 16:12:40 -0400
I have to reuse an old Symantec 7.0 firewall on NT. Looking at the documentation for an SGS and looking at the actual firewall GUI, I am hoping that documentation is just about the same in terms of content. Scenario: I have several networks connected by frame relay a cisco router. The router currently performs NAT'g really PAT'g(Port Address Translation/Overloading) i.e. each network is mapped to a particular ip Address. So 192.16.8.0 is mapped to 172.20.16.8, 192.16.9.0 is mapped to 172.20.16.9,... As I understand it, Dynamic NAT'g maps a group of Addresses on the inside of the network to a group of address on the outside of the network or DMZ. Or 192.16.8.0/24 is mapped to 172.20.8.0/24, 192.16.9.0/24 is mapped to 172.20.9.0/24 Static NAT'g map single address on the inside to a single address on the outside. Or 192.16.8.3 is mapped to 172.20.8.3, or 192.16.8.4/30 is mapped 172.20.8.4/30(here the addresses are mapped one to one: 192.16.8.4->172.20.8.4,192.16.8.5->172.20.8.5,... Question: How does one implement PAT on a Symantec Firewall? Question: Is it possible to create multiple logical network interfaces on the outside interface and use one of those logical interfaces in Address Transforms? Thank you, Raymond
_______________________________________________ firewall-wizards mailing list firewall-wizards () listserv icsalabs com https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
Current thread:
- Need to PAT several Networks on Symantec 7.0 firewall. Jacob, Raymond A Jr (May 26)