Wireshark mailing list archives
How to compile and execute the source code of wireshark?
From: JAI BHAGWAN YADAV <saurav.yadav0005 () gmail com>
Date: Thu, 18 Jun 2015 19:47:45 +0530
Hello all, I am a beginner, Q- How to compile and execute the source code of wireshark so that (i) Whenever I will compile and execute it, it will also run wireshark (ii) I will use printf firstly so I can see the output at terminal O.S. used: 64 bit, Ubuntu 12.04 What I tried? I have tried ./autogen.sh It run successfully. then ./configure It also run successfully, takes 2 minutes to execute on my system (1 GB RAM, virtual machine). then make It also run successfully, takes 15-20 approx minutes to execute. Only warnings can be seen in between of these execution but no error occured. *But also no wireshark window get opened, it will only open when I execute the command ./wireshark. So, please tell me the correct way and order to write all the commands*. I want to make changes in the menu bar so that it will show the changes made in the wireshark and also print the output of the printf instruction I will put in one of the code. Thanks and regards
___________________________________________________________________________ Sent via: Wireshark-dev mailing list <wireshark-dev () wireshark org> Archives: https://www.wireshark.org/lists/wireshark-dev Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev mailto:wireshark-dev-request () wireshark org?subject=unsubscribe
Current thread:
- How to compile and execute the source code of wireshark? JAI BHAGWAN YADAV (Jun 18)
- Re: How to compile and execute the source code of wireshark? Pascal Quantin (Jun 18)
- Re: How to compile and execute the source code of wireshark? Graham Bloice (Jun 18)
- Re: How to compile and execute the source code of wireshark? Guy Harris (Jun 18)