Err when using a pipe

[vijay <vijay.prasanth () gmail com>]

Hi,

I start wireshark from command line : "sudo ./wireshark -k -i /tmp/pipe"

I have a capture dump in libpcap format which i wite into the pipe
(/tmp/pipe) after starting wireshark. Everytime i do this wireshark
displays the contents of the file but at the end it shows segmentation
fault. The capture file is from my previous run of wireshark saved in
libpcap format.

Wireshark perfectly works with the same file when open though GUI. I am
using wireshark 1.6.5 on linux. Could some one pls tell me
why this behavior occurs?

Thanks
Vijay

___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev () wireshark org>
Archives:    http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
             mailto:wireshark-dev-request () wireshark org?subject=unsubscribe