tcpdump mailing list archives
Re: DLT_request
From: Guy Harris <guy () alum mit edu>
Date: Thu, 12 Jan 2017 00:51:29 -0800
On Jan 11, 2017, at 11:42 PM, Weber René <rweber () baumer com> wrote:
We working at software for industrial cameras which are supported by the cameralink standard. We use Wireshark to monitor the control interface. We have implemented a solution similar like the u3v dissector and uses link type DLT_USER0. The cameralink interface is basically a serial interface like rs232 uart.
So this is for GenCP over a serial port, rather than GenCP-over-UDP?
But often exist this only inside the application and not as separate comport. The using of DLT_USER0 is not so comfortable, because the protocol at every user is at first to set to cameralink ... Therefore, I'm requesting a DLT_ value for this. Please let me know what the proper procedure is for this or if you have any other questions/concerns.
So do the packets in such a pcap or pcapng file start with the serial prefix described in section 1.5 "Serial Prefix", followed by the common command data described in section 4.3 "Common Command Data", followed by the specific command data for the command in question (section 1.6 "Serial Postfix" says there's no postfix for serial ports)? (Presumably the same code can be used to dissect the common command data + specific command data for GenCP-over-UDP.) _______________________________________________ tcpdump-workers mailing list tcpdump-workers () lists tcpdump org https://lists.sandelman.ca/mailman/listinfo/tcpdump-workers
Current thread:
- DLT_request Weber René (Jan 11)
- Re: DLT_request Guy Harris (Jan 12)
- Re: DLT_request Weber René (Jan 13)
- Re: DLT_request Guy Harris (Jan 13)
- Re: DLT_request Weber René (Jan 17)
- Re: DLT_request Weber René (Jan 13)
- Re: DLT_request Guy Harris (Jan 12)