Nmap Development mailing list archives
Re: nmap v6.00 - problems if a wlan interface is installed/activated
From: Tom Eichstaedt <wintermute () tom-e de>
Date: Mon, 04 Jun 2012 13:01:27 +0200
Am 04.06.2012 00:01, schrieb Djalal Harouni:
Hi, Ok, thanks for reporting this. Could you please run these commands and send us results (with that patch).
Yes, of course. > # ./nmap --iflist -d3 ======================================================================= Starting Nmap 6.00 ( http://nmap.org ) at 2012-06-04 12:33 CEST Fetchfile found /usr/bin/../share/nmap/nmap-services PORTS: Using top 1000 ports found open (TCP:1000, UDP:0, SCTP:0) ************************INTERFACES************************ DEV (SHORT) IP/MASK TYPE UP MTU MAC lo (lo) 127.0.0.1/8 loopback up 16436lan-1 (lan-1) 10.100.0.10/24 ethernet up 1500 00:30:18:4B:9E:CD wan-1 (wan-1) 192.168.2.1/24 ethernet up 1500 00:30:18:4B:9E:CC unused-1 (unused-1) (null)/0 ethernet down 1500 00:30:18:4B:9E:CB unused-2 (unused-2) (null)/0 ethernet down 1500 00:30:18:4B:9E:CA wlan-1 (wlan-1) 10.100.1.10/24 ethernet up 1500 00:1D:0F:FE:BF:C4 mon.wlan-1 (mon.wlan-1) (null)/0 ethernet up 1500 00:1D:0F:FE:BF:C4
ppp0 (ppp0) xxx.xxx.xxx.xxx/32 point2point up 1492
ROUTES: NONE FOUND(!)
Reason:
=======================================================================
> # ifconfig -a
=======================================================================
lan-1 Link encap:Ethernet HWaddr 00:30:18:4b:9e:cd
inet addr:10.100.0.10 Bcast:0.0.0.0 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:9597 errors:0 dropped:0 overruns:0 frame:0
TX packets:12546 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1151466 (1.0 MiB) TX bytes:14362853 (13.6 MiB)
Interrupt:16 Base address:0xa000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1547 errors:0 dropped:0 overruns:0 frame:0
TX packets:1547 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:120698 (117.8 KiB) TX bytes:120698 (117.8 KiB)
mon.wlan-1 Link encap:UNSPEC HWaddr
00-1D-0F-FE-BF-C4-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:206 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:28119 (27.4 KiB) TX bytes:0 (0.0 B)
ppp0 Link encap:Point-to-Point Protocol
inet addr:xxx.xxx.xxx.xxx P-t-P:xxx.xxx.xxx.xxx
Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:20232 errors:0 dropped:0 overruns:0 frame:0
TX packets:17590 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:19323473 (18.4 MiB) TX bytes:2000878 (1.9 MiB)
unused-1 Link encap:Ethernet HWaddr 00:30:18:4b:9e:cb
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:18 Base address:0xe000
unused-2 Link encap:Ethernet HWaddr 00:30:18:4b:9e:ca
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:19
wan-1 Link encap:Ethernet HWaddr 00:30:18:4b:9e:cc
inet addr:192.168.2.1 Bcast:0.0.0.0 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:20820 errors:0 dropped:0 overruns:0 frame:0
TX packets:18178 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:19803931 (18.8 MiB) TX bytes:2423212 (2.3 MiB)
Interrupt:17 Base address:0xc000
wlan-1 Link encap:Ethernet HWaddr 00:1d:0f:fe:bf:c4
inet addr:10.100.1.10 Bcast:0.0.0.0 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6855 errors:0 dropped:8 overruns:0 frame:0
TX packets:6735 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:878570 (857.9 KiB) TX bytes:5438773 (5.1 MiB)
=======================================================================
> # cat /proc/net/route
=======================================================================
Iface Destination Gateway Flags RefCnt Use Metric
Mask MTU Window IRTT
ppp0 00000000 xxxxxxxx 0003 0 0 0
00000000 0 0 0
lan-1 0000640A 00000000 0001 0 0 0
00FFFFFF 0 0 0
wlan-1 0001640A 00000000 0001 0 0 0
00FFFFFF 0 0 0
wan-1 0002A8C0 00000000 0001 0 0 0
00FFFFFF 0 0 0
ppp0 xxxxxxxx 00000000 0005 0 0 0
FFFFFFFF 0 0 0
=======================================================================
> # ip addr show
=======================================================================
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
2: lan-1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UNKNOWN qlen 1000
link/ether 00:30:18:4b:9e:cd brd ff:ff:ff:ff:ff:ff
inet 10.100.0.10/24 scope global lan-1
3: wan-1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UNKNOWN qlen 1000
link/ether 00:30:18:4b:9e:cc brd ff:ff:ff:ff:ff:ff
inet 192.168.2.1/24 scope global wan-1
4: unused-1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN qlen 1000
link/ether 00:30:18:4b:9e:cb brd ff:ff:ff:ff:ff:ff
5: unused-2: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN qlen 1000
link/ether 00:30:18:4b:9e:ca brd ff:ff:ff:ff:ff:ff
6: wlan-1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
qlen 1000
link/ether 00:1d:0f:fe:bf:c4 brd ff:ff:ff:ff:ff:ff
inet 10.100.1.10/24 scope global wlan-1
7: mon.wlan-1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state
UNKNOWN qlen 1000
link/ieee802.11/radiotap 00:1d:0f:fe:bf:c4 brd ff:ff:ff:ff:ff:ff
8: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1492 qdisc
pfifo_fast state UNKNOWN qlen 3
link/ppp
inet xxx.xxx.xxx.xxx peer xxx.xxx.xxx.xxx/32 scope global ppp0
=======================================================================
> # ip route show
=======================================================================
default via xxx.xxx.xxx.xxx dev ppp0
10.100.0.0/24 dev lan-1 proto kernel scope link src 10.100.0.10
10.100.1.0/24 dev wlan-1 proto kernel scope link src 10.100.1.10
192.168.2.0/24 dev wan-1 proto kernel scope link src 192.168.2.1
xxx.xxx.xxx.xxx dev ppp0 proto kernel scope link src xxx.xxx.xxx.xxx
=======================================================================
> If you can also send the same results of Nmap v5.51 that would be a plus.
> # ./nmap --iflist -d3
=======================================================================
Starting Nmap 5.51 ( http://nmap.org ) at 2012-06-04 12:45 CEST
************************INTERFACES************************
DEV (SHORT) IP/MASK TYPE UP MTU MAC
lo (lo) 127.0.0.1/8 loopback up 16436
lan-1 (lan-1) 10.100.0.10/24 ethernet up 1500 00:30:18:4B:9E:CD
wan-1 (wan-1) 192.168.2.1/24 ethernet up 1500 00:30:18:4B:9E:CC
wlan-1 (wlan-1) 10.100.1.10/24 ethernet up 1500 00:1D:0F:FE:BF:C4
ppp0 (ppp0) xxx.xxx.xxx.xxx/32 point2point up 1492
**************************ROUTES**************************
DST/MASK DEV GATEWAY
xxx.xxx.xxx.xxx/32 ppp0
10.100.0.0/24 lan-1
10.100.1.0/24 wlan-1
192.168.2.0/24 wan-1
0.0.0.0/0 ppp0 xxx.xxx.xxx.xxx
=======================================================================
(The other results are identically, because it's the same box.)
> I'll try to investigate it.
Thanks a lot.
Cheers, Tom
_______________________________________________
Sent through the nmap-dev mailing list
http://cgi.insecure.org/mailman/listinfo/nmap-dev
Archived at http://seclists.org/nmap-dev/
Current thread:
- nmap v6.00 - problems if a wlan interface is installed/activated Tom Eichstaedt (May 26)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Daniel Miller (May 26)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated David Fifield (May 27)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Tom Eichstaedt (May 28)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Djalal Harouni (May 29)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Djalal Harouni (Jun 02)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Daniel Miller (Jun 02)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Tom Eichstaedt (Jun 03)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Djalal Harouni (Jun 03)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Tom Eichstaedt (Jun 04)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Djalal Harouni (Jun 27)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Tom Eichstaedt (Jun 30)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated David Fifield (May 27)
- Re: nmap v6.00 - problems if a wlan interface is installed/activated Daniel Miller (May 26)