nanog mailing list archives
Re: Temperature monitoring
From: Richard Holbo <holbor () sonss net>
Date: Thu, 13 Jul 2017 22:45:30 -0700
http://tyconsystems.com/index.php/products/tycon-power/tpdin-monitor-web/751-tpdin-monitor-web2 Is what I use in my cabinets. Has two temp sensors, one internal and one external. I put the external near the AC cold air output so I can get a diff and know if the AC is on. SNMP cacti graphs them nicely. I use one of the voltage sensors to monitor the cabinet doors via reed switches. In remote mountain sites also use for battery/solar voltages and to monitor wall warts for Utility power loss. /rh On Thu, Jul 13, 2017 at 7:33 PM, Dovid Bender <dovid () telecurve com> wrote:
All, We had an issue with a DC where temps were elevated. The one bit of hardware that wasn't watched much was the one that sent out the initial alert. Looking for recommendations on hardware that I can mount/hang in each cabinet that is easy to set up and will alert us if temps go beyond a certain point. TIA. Dovid
Current thread:
- Temperature monitoring Dovid Bender (Jul 13)
- Re: Temperature monitoring Gary E. Miller (Jul 13)
- Re: Temperature monitoring Andrew Latham (Jul 13)
- Re: Temperature monitoring Peter Beckman (Jul 18)
- Re: Temperature monitoring Harlan Stenn (Jul 13)
- Re: Temperature monitoring Nick Hilliard (Jul 14)
- Re: Temperature monitoring Pete Baldwin (Jul 13)
- Re: Temperature monitoring Mel Beckman (Jul 13)
- Re: Temperature monitoring Richard Holbo (Jul 13)
- Re: Temperature monitoring Eric Kuhnke (Jul 13)
- Re: Temperature monitoring Eric Kuhnke (Jul 14)
- Re: Temperature monitoring Dan White (Jul 14)
- Re: Temperature monitoring David Charlebois (Jul 16)
- RE: Temperature monitoring Edwin Pers (Jul 18)
- Re: Temperature monitoring David Charlebois (Jul 16)