Re: EoMPLS vlan rewrite between brands; possibly new bug in Cisco IOS 15

[Jonas Bjork <mr.jonas.bjork () me com>]

Dear Mr. Jeff,

Thank you for your reply. Below is the complete output in question (l2 is short for l2transport).
You are mentioning platform capabilities and that the default might have changed. How do I alter this?

pe#sh mpls l2 vc 42 d
Local interface: Po190.42 up, line protocol up, Eth VLAN 42 up
  Destination address: X.X.1.89, VC ID: 42, VC status: down
    Last error: Imposition VLAN rewrite capability mismatch with peer
    Output interface: none, imposed label stack {}
    Preferred path: not configured
    Default path: no route
    No adjacency
  Create time: 00:00:59, last status change time: 00:31:40
    Last label FSM state change time: 00:00:18
    Last peer autosense occurred at: 00:00:18
  Signaling protocol: LDP, peer X.X.1.89:0 up
    Targeted Hello: X.X.0.2(LDP Id) -> X.X.1.89, LDP is UP
    Graceful restart: not configured and not enabled
    Non stop routing: not configured and not enabled
    Status TLV support (local/remote)   : enabled/not supported
      LDP route watch                   : enabled
      Label/status state machine        : remote invalid, LruRnd
      Last local dataplane   status rcvd: No fault
      Last BFD dataplane     status rcvd: Not sent
      Last BFD peer monitor  status rcvd: No fault
      Last local AC  circuit status rcvd: No fault
      Last local AC  circuit status sent: DOWN PW(rx/tx faults)
      Last local PW i/f circ status rcvd: No fault
      Last local LDP TLV     status sent: No fault
      Last remote LDP TLV    status rcvd: Not sent
      Last remote LDP ADJ    status rcvd: No fault
    MPLS VC labels: local 242, remote 1199
    Group ID: local 0, remote 0
    MTU: local 9216, remote 9216
    Remote interface description:
    Remote VLAN id: 42
  Sequencing: receive disabled, send disabled
  Control Word: Off (configured: autosense)
  SSO Descriptor: X.X.1.89/42, local label: 242
  Dataplane:
    SSM segment/switch IDs: 0/0 (used), PWID: 142
  VC statistics:
    transit packet totals: receive 0, send 0
    transit byte totals:   receive 0, send 0
    transit packet drops:  receive 0, seq error 0, send 0
pe#

Anyone else: feel free to join in. Maybe we have any L2VC/PW ninjas watching.

Best regards,
Jonas Bjork


> On 15 Nov 2015, at 1:26, Jeff Tantsura <jeff.tantsura () ericsson com> wrote:
>
> Been forever since i looked at cisco, however sounds like vc type mismatch. They used to have it as a platform 
> capability, perhaps SW upgrade changed the default.
>
> to my memory "show mpls l2 transport" should provide enough details.
>
> Hope this helps
>
> Regards,
> Jeff
>
> > On Nov 14, 2015, at 4:50 AM, Jonas Bjork <mr.jonas.bjork () me com> wrote:
> >
> > Hi, I am using a couple of AToM/EoMPLS tunnels in order to carry customer voice and data traffic across our IP/MPLS 
> > core, and it is currently working just fine. The first side consists of a Cisco 7600 router (rsp) and the other one 
> > is an HP A5500-HI routing switch with full LER/E-LSR capability. At the HP site, the tunnels are facing the access 
> > ports towards our premium end-customers; and on the Cisco PE I terminate the tunnels on one of the 2x10GE 
> > portchannel backbone links. There is vlan X on the HP side and vlan Y on the Cisco side - vlan rewrite is working 
> > perfectly - as long as I use IOS 12.
> >
> > After upgrading the Cisco router software to IOS 15 the tunnels won't come up. sh mpls l2 vc Y d says:
> > ...
> > Last error: Imposition VLAN rewrite capability mismatch with peer
> > ...
> >
> > I use almost exactly the same Cisco configuration before and after the upgrade (only minor changes and nothing 
> > related to this) and I havn't touched the HP. Apparently they don't talk the same L2PW language. I wonder though, 
> > why now? We use service instances on the HP switchport as endpoint, we initiate the targetted LDP session in 
> > addition to the pseudowire handshake from a sub interface MPLS crossconnect. There is no MTU mismatch; not here - 
> > not anywhere.
> >
> > Anyone heard of this issue or experienced it?
> >
> > Best regards,
> >
> > Jonas Björk
> > SNE, Europe/Sweden (hope you guys will help me anyway:)