RE: Managing free pairs to prevent DSL sync. loss

["Matlock, Kenneth L" <MatlockK () exempla org>]

-----Original Message-----
From: valdis.kletnieks () vt edu [mailto:valdis.kletnieks () vt edu] 

> No, it will be strictly a DC current, with the amperage easily
calculated from the voltage difference between the two ends and the
resistance of 
> however many cable-feet of wire is involved.  Not usually a big deal,
unless your termination design didn't include the ability to sink a DC
current 
> 24/7.

> (Of course, actually measuring the voltage and resistance may be
non-trivial :)

That brings up an interesting question. I assumed the ground potential
stays the same between 2 points, but have there been any studies to see
if it's actually DC, or if there's an AC component to it? 

If there's an AC component in the ground at either end (or both) that
may introduce EM into adjacent pairs across the cable. And are they more
or less than the EM ungrounded pairs would pick up?

Ken Matlock
Network Analyst
303-467-4671
matlockk () exempla org

*** SCLHS Confidentiality Notice *** The information contained in this message may be privileged and confidential and 
protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent 
responsible for delivering this message to the intended recipient, you are hereby notified that any other 
dissemination, distribution or copying of this communication is strictly prohibited. If you have received this 
communication in error, please notify me immediately by replying to the message and deleting it from your computer. 
Thank you. *** SCLHS Confidentiality Notice ***