nanog mailing list archives
Re: can I ask mtu question
From: "Ricky Beam" <jfbeam () gmail com>
Date: Fri, 30 Jan 2009 16:33:43 -0500
On Fri, 30 Jan 2009 12:57:25 -0500, adrian kok <adriankok2000 () yahoo com hk> wrote:
What is max mtu in jumbo frame?
That depends on the hardware. I've seen gear running as low as ~8k. I'd have to consult standard, but I think the max is 10k (10240).
Keep in mind the switch is not the only device on the network with jumbo frame limits. The NICs in your servers will also have limits.
Do I need to reboot the switch to take effect after setting up it?
Again, this depends on the system. Many accept the change immediately, while others have to rebooted or interfaces reset to effect the change.
if it doesn't need to reboot, How can I know the switch is running fine in this mtu 9000? eg: cisco any tools to check?
"ping" will do. Set the packet size larger than the normal MTU (1500) and see if it crosses the network intact. If it's not working, A) the packets will be dropped, and B) the "oversized frame" counter (among others) should be clocking errors.
--Ricky
Current thread:
- can I ask mtu question adrian kok (Jan 30)
- RE: can I ask mtu question Paul Stewart (Jan 30)
- RE: can I ask mtu question Michael Smith (Jan 30)
- Re: can I ask mtu question Brad Fleming (Jan 30)
- Re: can I ask mtu question Ricky Beam (Jan 30)
- Re: can I ask mtu question Justin M. Streiner (Jan 30)
- Re: can I ask mtu question Ricky Beam (Jan 30)
- Re: can I ask mtu question sthaug (Jan 30)
- Re: can I ask mtu question Saku Ytti (Jan 30)
- Re: can I ask mtu question Ricky Beam (Jan 30)
- Re: can I ask mtu question Justin M. Streiner (Jan 30)