RATE-Limiting and

["Vandy Hamidi" <vandy.hamidi () markettools com>]

Excellent point.  It does depend on the traffic type.
Though I don't like to complicated my configs, you can always use CAR (cisco rate limiting) through an ACL to protect 
against the file transfer from the core servers issue you referred to below.  It can make sure a high bandwidth xfer 
won't suck up all your available B/W.

Does anyone out there know how to limit B/W based on Flow or individual sessions?  Or even just source (where source is 
random).  For example, a CAR where each IP source gets no more than X% of B/W (still allowing bursts if bandwidth is 
available).  I think some QOS tagging and queuing would have to be involved.

        -=Vandy=-

-----Original Message-----
From: Jack Bates [mailto:jbates () brightok net]
Sent: Thursday, July 03, 2003 4:43 AM
To: Andy Dills
Cc: Vandy Hamidi; prue; nanog () merit edu
Subject: Re: Newbie network upgrade question, apologies in advance to
NANOG


Andy Dills wrote:
> Yes, but the original poster was dealing with DS3s connected to different
> NAPs, which is why the packet out-of-order issue can be significant.

I'd say that a more significant issue is customer throughput. The nice 
aspect of per conn is that it not only tends to keep a decent load 
balance, it also limits bandwidth hogs from saturating all circuits. 
This of course depends on your desired result. An example in my case is 
my helpdesk. They are off two t1's with dsl and dialup customers. I'd 
prefer them not to tank both t1's when transfering files to and from the 
core servers.

-Jack